Remodels in the Flats and up in the hills tend to set the cooktop into marble, quartzite or another natural stone with a very tight reveal, sometimes so tight that the steel frame looks painted onto the slab. Owners understandably worry that any repair means prying the unit out. In practice, a good share of cooktop faults never require that.
On a gas model, the burner caps, burner bases, igniters and much of the ignition wiring are reached from the top once the grates and caps are off. Valves, the spark module and the gas connection are usually reached from the cabinet underneath, working upward. On induction, the cooling fan, wiring and some control components can often be reached from below as well, depending on how the cabinetry was built around the unit.
Lifting the cooktop out of its cutout becomes necessary when a part can only be removed from above the glass or the burner tray, when the glass itself is cracked, or when the cabinet below is closed off by drawers or a built-in panel that cannot come out. In that case the bead of sealant around the edge is cut carefully, the unit is raised straight up rather than levered against the stone, and the opening is cleaned before the cooktop goes back in.
Because of all this, the technician will ask about the counter before the visit: what the stone is, whether the edge around the cutout is thin, and whether the slab has ever been repaired. A few honest answers decide how the job is approached and how long the visit should be. If a steam oven or wall oven sits in the same run of cabinets, mention it too; it shares the same trip and the same fee.